1992-1998 Polaris Personal Watercraft Service Manual PN 9912201, Page 389Get this manual

1992-1998 Polaris Personal Watercraft Service Manual PN 9912201, Page 389

FINAL DRIVEJET PUMPBILGE SYSTEM Driveshaft Lubrication (All Models) Driveshaft Lubrication Grease the drive shaft coupler
1Remove lanyard cord and lock plate from the engine stop switch 2Remove seatRemove battery ground (-) cable34Loosen clamp
holding plastic driveshaft shroud in place and rotate it 180 (See III1)Solid Couplersturn driveshaft coupler until grease
fitting is accessibleBonded rubber couplersdrive shaft must be removed to grease splinesSee maintenance guidelines in Maintenance
Section, and refer to drive shaft removal in this sectionUsing grease gun with Polaris grease gun adaptor lubricate coupler
at the grease fitting until the coupler boot just begins to expandLubricate bearing housing at grease fitling until grease
purges past the sealsUse only Polaris Premium Marine or All Purpose grease1992-1994 Solid Coupler (Grease at fitting) Front
of Watercraft Grease Fittings) Coupler Boot Rotate Driveshaft Guard Bonded Rubber Coupler (Must remove drive shaft to grease)