1992-1998 Polaris Personal Watercraft Service Manual PN 9912201, Page 430Get this manual

1992-1998 Polaris Personal Watercraft Service Manual PN 9912201, Page 430

HULUDECK, STEERING AND CONTROLS SMC Repair SMC Hull Repair (All Except 1994-1995 SLT and 1996 SLT700 Models) The hull and
of the adhesive so old adhesive is not used NOTE: See paint information in General Information section for paint colors Do
not use power sanding equipment on the repair area or bond strength may be affectedHand sand onlyNOTE: For bonding use 3M
#08101 structural adhesive or equivalentExample shown is through hull fitting installationBasic preparation procedure is
the same for repairing damaged hulldeck components1Remove all original adhesive and sand the area Power to be repaired with
80 grit papersanding is not recommendedbond strength may be adversely affectedUse acetone or lacquer thinner to clean and
prime the area around the repairI ' 2Mix parts and of the structural adhesive, apply to the fitting and hull, and immediately
press the parts into place holding pressure for at least two minutes until the adhesive begins to set upHandling strength
should be achieved within 30 minutesAllow 24 hours for total cure time before painting or putting into service Polaris Industries