1992-1998 Polaris Personal Watercraft Service Manual PN 9912201, Page 450Get this manual

1992-1998 Polaris Personal Watercraft Service Manual PN 9912201, Page 450

ELECTRICAL Charging SystemSwitch Testing Charging System Testing (Regulated Voltage) 1Turn multitester dial to volts DCand
board and starter solenoid or MFD wire 3Connect one of the test leads to the redpurple wire and the other lead to the yellowred
wireDepress start button The reading should be .3 ohms or lessA high resistance or open reading indicates faulty switch4Release
start button An open reading (Ol) should be indicatedIf low resistance is measured, replace the switch Engine Stop Switch
Testing 1Set multitester to ohms (Q) position23Unplug stop switch connector (blackyellow and black wires)Connect one of the
test leads to the blackyellow pin and the other lead to the black pinPush kill button or disconnect tether cord The reading