1992-1998 Polaris Personal Watercraft Service Manual PN 9912201, Page 548Get this manual

1992-1998 Polaris Personal Watercraft Service Manual PN 9912201, Page 548

ENGINECOOLING Cylinder Honing The Ni-Ca-Sil cylinders used on the SLX Pr0785 can be honed to remove light deposits or scuffing
hone in and out of the cylinder rapidly Remember to keep the hone drive shaft centered to prevent edge loading and always
bring the stone approximately 12" (1 .3 cm) beyond the bore at the end of each stroke Release the hone at regular intervals
to inspect the bore surface IMPORTANT: Cleaning the Cylinder After Honing It is very important that the cylinder be thoroughly
cleaned after honing to remove all grit materialWash the cylinder in solvent, then in hot soapy waterPay close attention