1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 108Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 108

FUEL SYSTEMCARBURETION Mixture Screw SettingsKeihin Idle Speed On Genesis FICHT models, the EMM is programmed to idle at
of the screws in each direction to compensate for changes in altitude and temperatureThe base settings should not be changedIf
large adjustments are necessary for proper mixture, the carburetors, fuel systemand engine should be inspected to find the
cause of rich or lean condition(See Lean Condition Troubleshooting in Maintenance section If the carburetor has been tampered
with or disassembled before exact base settings were recorded, use the following procedure to adjust each screwNote:The base
settings are for elevations between sea level and 3000 ft(900 meters)12Remove limiter cap(s)Turn mixture screw in until lightly
seated, then turn screw out the specified number of turns (see specifications in beginning of this chapter)Reinstall limiter