1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 156Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 156

ENGINE Oil Pump Oil Pump Bleeding The oil pump must be bled following any repair service to the injection system which might
oil supply lines with oil using small oil squirt can Troubleshooting NOTE: See Maintenance section for adjustmenVinspection
information 74Remove lines from their fi ttings at the engine and pumpBlow through them to ensure they are nol plugged restricted
75 Apply some pressure to the check valve fittings with the Mity VacTI'! or similar toolThese valves should open with 2-5
Ibsof pressure76 Be sure oil feed lines fit tightly, are not cracked or leaking77 Be sure the in-line filter between oil
pump and oil tank is clean and bleedi ng is complete78 If il still won't flow, replace the oil pu mp Oil Pump Check Valve
(located on CarburetorlThroltle Body) NOTE: This machine is eq uipped with variable oil pump controlled by link rod between
the carburetors and the pump armThis is non-adjustable rodIt is necessary to inspect the rod and linkage for correct installation