1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 157Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 157

ENGINE Engine InstallationPolaris Engines Engine Installation Engine installation is done in reverse order of the removal
engineMake sure all cables, hoses, and wiring are routed and secured properlyAdjust throttle cable and check throttle operationIt
must operate freely and return completely when releasedVerify proper operation of engine stop switchAfter engine installation,
pump alignment must be inspectedRefer to the Final Drive section for inspection and alignment proceduresSynchronize carburetors
and be sure they are cleanAdjust oil pump cable and bleed pumpThe first tank of fuel should be pre-mixed with Polaris Premium
cycle or Premium Synthetic cycle oil at 40: ratio CAUTION: Use new exhaust gaskets Shims used for engine and driveshaft alignment
must be reinstalled in their original locationsDo not allow them to be mixed upAlways verify proper engine to pump alignment
after engine installation as outlined in the Jet Pump, Final Drive, Bilge sectionIn most cases, the number of shims used