1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 165Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 165

Crankshaft Indexing 7With the pOinter aligned, make sure the degree wheel and pointer are secured and will not move out of
etc Rough idle, poor top speed Dial Caliper Crankshaft Indexing Be sure to keep the dial caliper vertical, and in the center
of the plug hole for greatest accuracy Disconnect battery ground cable and all spark plug high tension leadsGround high tension
leads to engineDisconnect lanyard from engine stop switch before proceeding with the following steps1Remove all spark plugs
2Install dial indicator into the magneto end (Front) cylinder spark plug hole(The ignition timing is referenced by the mag
end)3Rotate the engine to bring the piston to top dead center (TOe) on the cylinder with the dial indicator installed4Locate
TOe as accurately as possible by finding the center of the point where there is no piston movement, and zero the dial indicator
at this pointDo not move the crankshaft from this positionSUsing the dial caliper, measure the distance from the spark plug