1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 168Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 168

ENGINE Crankshaft Truing Crankshaft Truing Lubricate the bearings and clamp the crankshaft securely in the holding fixtureOn
with brass hammer HIGH .004 (.1 mm) HIGH .004 (.1 mm) NOTE: The rod pin position in relation to the dial indicator position
tells you what action is required to straighten the shaft SUPPORT CRANKSHAFT AT THESE TWO BEARINGS 11 To correct situation
like the one shown in the illustration at right, squeeze the crankshaft at point A(Use tool from alignment kit) HIGH .002
(.OSmm) .HIGH .005 (.13m m) 12 .If the crank rod pin location is ISOfrom the dial indicator (opposite that shown above),
it will be necessary to spread the crankshaft at the position as shown in the illustration at right When rebuilding and straightening