1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 177Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 177

FINAL DRIVEJET PUMPBILGE SYSTEM Intake Scoop and Ride Plate Installation Intake ScoopRide Plate Installation and Sealing,
12" (1.3 cm) or larger continuous bead of marine grade silicone sealant to the area shownBe sure to apply sealant between
hull and inlet scoop shown by arrows Marine Grade Silicone Sealant 300 mlTubePN 8560054 Install intake scoop, carefully push
into placeSet ride plate in place and secure it with attaching screwsWipe off any excess sealant inside scoop area so water
flow is unobstructedFor precise alignment of the scoop, install the pump housing immediately (see pump installation)IMPORTANT!