1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 184Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 184

FINAL DRIVEJET PUMPBILGE SYSTEM Pump Assembly Pump Assembly NOTE: To ease instatiation, wrap bearings in wax paper and chill
center spacer and press remaining bearing into opposite end of housingRemove stub shaftApply marine grease to seal lips and
also between the two sealsInstall two new oil seals as shown with both springs and lips up and visible (toward impeller)Press
seals to bottom of chamfer on seal bore (about 18".32 cm beyond end of bore) NOTE: Check pump alignment before installing
stub shaft and impellerSee page 5.25-5.29Grease and install two new O-rings on stub shaftAlign bearing spacer carefully and