1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 190Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 190

FINAL DRIVEJET PUMPBILGE SYSTEM Pump Drive Shaft Alignment The drive shaft must be properly aligned to prevent premature
lanyard cord lock plate from engine stop switchRemove battery negative cableRemove driveshaftpump assembly(See pump removal
this section)Remove bearing housing from through-hull fittingRemove tail coneRemove impeller and stub shaft from pump housingInspect
bearings for wear or damage and replace if necessarySee Pump DisassemblyInspection this sectionAssemble pump without stub
shaft, impeller, or tail coneInstall stator housing to pump housingTighten mounting bolts to 18 ftIbs(2.48 kg-m)3456Alignment
Tool PN 2871343 Stator Housing Mounting Bolt Torque -18 ftlb (2.48 kg-m) Install alignment tool into pump bearing housing
with the smaller diameter coupler end facing toward engineSlide coupler end of alignment tool into drive couplerWatercraft
EnginePump Alignment Tool PN 2871343 10If engine and pump are properly ligned, the tool wi ll slide freely into the engine