1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 217Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 217

HULUDECK, STEERING AND CONTROLS SMC Repair SMC Hull Repair The hull and top deck on some models are constructed of sheet
See paint information in General Information section for paint colorsDo not use power sanding equipment on the repair area
or bond strength may be affectedHand sand onlyNOTE: For bonding use 3M #08101 structural adhesive or equivalentExample shown
is through hull fitting installationBasic preparation procedure is the same for repairing damaged hulldeck componentsRemove
all original adhesive and sand the area to be repaired with 80 grit paperPower sanding is not recommendedbond strength may
be adversely affectedUse acetone or lacquer thinner to clean and prime the area around the repairMix parts and of the structural
adhesive, apply to the fitting and hull, and immediately press the parts into place holding pressure for at least two minutes