1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 255Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 255

ELECTRICAL Ignition Timing AdjustmentGenesis X-4S Dynamic Ignition Timing, Cont12Point timing light at inspection holeBe
Static Timing Ught tool (PN 2871745) can used to check ignition timing on Polaris engines equipped with hall effect sensorsBe
sure to set the timing to the "Static Timing Reference Location" shown in Static Timing Table when using the Static Timing
Ught1Make sure there is good 9v battery in the tool2Open electrical box, disconnect brown stator lead and connect it to brown
lead of tester3Disconnect gray stator lead and connect it to black lead of tester4Connect white wire to Red (Magneto cylinder-#I)
stator wireThe white wire on the tool is the sensor wire and must be connected to the Mag cylinder Hall-Effect sensor wire
RedMag (#1) cylinder5Remove spark plugs and install dial indicator (with extension) in the Magneto (1) cylinderFind Top Dead
Center (T OC)6Rotate crankshaft counterclockwise (as viewed from front) until light comes onContinue rotating in same direction
until light goes offRotate an additional 1S turn or so, then reverse rotation direction (turn clockwise) Read the dial indicator