1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 282Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 282

FICHT FUEL INJECTION Action StepsFuel System Step 6: Voltage Supply TestsBattery must be of adequate capacity, fully charged
of EMM and connect FICHT EMM Service Power Connector (PN 2872456)Tether cord connected to stop switchengine not runningCrankingapproximately
20 voltsEngine runningmore than 24 volts and steady at idleMore than 40 volts and steady above 3500 RPMResults: As specifiedcheck
supply voltage at injectorGo to Step OAny less than specifiedtest charging system ECheck injector supply vOltage at the leads
of each injector connector using PDS(injector) jumper tool PN 2872623Voltage can also be monitored using FFI TM Diagnostic
SoftwareResults: Same results in Stepall OKNo voltage on somecheck voltage at the blue (29), purple (19), and green (9) injector
wires of the EMM pinoutOKrepair wire or replace engine wiring harnessNo voltageReplace EMMNo voltage on allReplace EMM Conclusion