1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 283Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 283

FICHT FUEL INJECTION Action StepsIgnition System ACTION STEPSIGNITION SYSTEM NOTE: Extract any service codes before troubleshootingCorrect
EMMVerify repairNo voltage on allgo to Step 5 Step 5: Voltage Supply TestsThe battery must be fully charged, with all connections
clean and tightAVerify tether cord is connected to stop switch NOTE: Perform the following tests while problem is occuringBVerify
fused B+(battery positive) is present at RedPurple wireterminals and of the PCM (see Chapter 9, page 22)Check should show
either9.5 or more volts while cranking, or 13 ormore volts while running OKgo to Step CNo voltage or low voltage while runningtest
Stop CircuitSee Step BLow voltage while cranking: -Verify battery capacity, condition, and connectionsTest voltage drop across
battery cables and starter solenoid-Test current draw of starter motorSee Engine Section CVerify output VOltage to EMM at
stator connectorsCheck for both of the following Tether cord connected to stop switchengine not runningCrankingapproximately