1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 285Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 285

FICHT- FUEL INJECTION Service Code Retrieval SERVICE CODE RETRIEVAL EMM service codes can be retrieved two different ways;
steps in the order shown; if performed out of sequence, the diagnostic mode will not be entered Step Step 1: Remove the tether
cord from stop switch 2: Remove S-pin connector from rear of EMM Connect EMM Service Power Connector (PN 2872456) to PCM
connector Step 4: Open MFI housing compartment from under hoodUnplug MFI and plug in Service Code Light tool to MFI wiring
harness Step 5: Remove TPS (Throttle Position Sensor) connector from the switchPlug in separate PS, or plug in TPS jumper
tool PN 2872603 to the red and green wiresIf using asepartate TPS, move TPS cam tothe fullest limit of its travel (i.esimulating
wide-open throttle), and attach some device to hold it there such as rubber band or tie strapIf using TPS jumper tool PN
2872603 the TPS will already read W.O.T6: Connect tether cord to stop switchThis will supply power to the EMM along with
Service Power Connector PN 2872456Tether cord must remain attached throughout test Step 7: Wait 10 secondsIf the TPS is moved