1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 293Get this manual

1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 293

DIAGNOSTIC SOFTWARE Error Messages If the program doesn't start, an error message will appear explaining the problemIf the
for your computer to determine the name of the port you have plugged the diagnostic communication cable intoMake sure the
diagnostic program is set up to use the same portSee the section titled Changing Com Port in this bookletSome computers have
the ability to enable and disable the com portsConsult the documentation that came with your computerMake sure the corn port
is enabled Something is already using the corn portThis is usually caused by mouse driver that is loaded in the Config.sys
file or Autoexec.bat fileIf you are using DOS or newer, you can bypass the Config.sys and Autoexec.bat files by restarting