1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 24Get this manual

1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 24

MAINTENANCEITUNE UP Lubrication Drive Shaft Lubrication WARNING The plastic driveshaft shroud is designed to protect you
180 Shroud Clamp (Loosen) Driveshaft Coupler (Solid) Turn driveshaft coupler until grease fitting is accessibleUsing grease
gun with needle point, lubricate coupler at grease fitting until coupler boot just begins to expand5Reposition driveshaft
shroud (open side down) and torque clamp screw to 25 inIbs6Reconnect battery ground (negative) cableBonded Rubber Coupler
7Reinstall seatDriveshaft splines should be lubricated during pre -$eason maintenance, every 100 hours, or when pump is disassembledSealing
a-rings at impeller end and inside coupler should be inspected and replaced if worn or damaged Refer to Final Drive section
for driveshaft removal procedureUse Premium All Season GreaseBonded Rubber Coupler Lubricate a-ring and Splines Forward Bearing