1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 50Get this manual

1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 50

MAINTENANCErrUNE UP Fuel System Manual Carburetor Synchronization NOTE: This procedure is very accurate when performed carefully
or PTO (twin cylinder) throttle plate to the same position as idle stop screw end using synchronizing screw (see photo at
right Adjust throttle plate to the same position as the other carburetor(s)3"C U'IIf carburetors are off the engine, verify
proper sync using 116" diameter twist drill or rigid wire gauge approximately .060" in diameterOpen throttle with idle screw
until the drill bit or wire passes under mag end plate with very slight dragAdjust all carbs in the same manner with sync
screwsAfter adjustment, set idle speed initially by closing plates and turning idle screw back in one half turnDo not damage
throttle plate with wire gauge8Readjust throttle leve freep lay Throttle Lever Freeplay .020.060" (.51.5 mm) III ::::I I: