1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 218Get this manual

1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 218

ENGINECOOLING Cylinder HoningPro 785 The Ni-Ca-Sil cylinders used on the Pro785 can be honed to remove light deposits or
RPM, run the hone in and out of the cylinder rapidlyRemember to keep the hone drive shaft centered to prevent edge loading
and always bring the stone approximately 12(1.3 cm) beyond the bore at the end of each strokeRelease the hone at regular
intervals to inspect the bore surface IMPORTANT: Cleaning the Cylinder After Honing It is very important that the cylinder
be thoroughly cleaned after honing to remove all grit materialWash the cylinder in solvent, then in hot soapy waterPay close
attention to the port areasUse electrical contact cleaner if necessary to clean these areas Rinse thoroughly, dry with compressed