1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 239Get this manual

1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 239

FINAL DRIVEJET PUMPBILGE SYSTEM Intake Scoop and Ride Plate Installation Intake Scoop Ride Plate Installation and Sealing,
12" (1.3 cm) or larger continuous bead of RTV silicone sealant to the area shown" 2Install intake scoop, carefully push into
place 3III ::::I I: III Set ride plate in place and secure it with attaching screws Wipe off any excess sealant inside scoop
area so water flow is unobstructedFor precise alignment of the scoop, install the pump housing immediately (see pump installation)IMPORTANT!