1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 246Get this manual

1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 246

FINAL DRIVEJET PUMPBILGE SYSTEM Pump Assembly Pump Assembly NOTE: To ease installation, wrap bearings in wax paper and chill
and press remaining bearing into opposite end of housingRemove stub shaft Apply marine grease to seal lips and also between
the two sealsInstall two new oil seals as shown with both springs and lips up and visible (toward impeller)Press seals to
bottom of chamfer on seal bore (about 18".32 cm beyond end of bore) NOTE: Check pump alignment before installing stub shaft
and impellerSee page 5.24-5.27 Grease and install two new -rings on stub shaftAlign bearing spacer carefully and push shaft