1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 282Get this manual

1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 282

HULUDECK, STEERING AND CONTROLS Cable Adjustments Alternate Method Of Measuring Nozzle Following is an alternate method for
Adjustment Procedure 1Minor adjustments can be made using the steering cable rod end(s)Loosen jam nut on rod end(s)Remove
end from top of steering nozzleTurn rod end in or out to adjustReinstall rod end, apply Loctite 242 (Blue) and tighten bolt
to specificationsSee III2 Small adjustments can be made with rod end(s) The cable must be threaded into the rod end minimum
of 38" (1 Omm)Do not attempt major adjustments with the rod ends Wire Clip Replacement 12If replacement of the wire clips
becomes necessary, thoroughly clean the area around the anchor with lacquer thinner or acetone Apply two part epoxy to the