1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 302Get this manual

1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 302

ELECTRICAL Charging SystemSwitch Testing Charging System Testing (Regulated Voltage) 12Turn multitester dial to volts DCand
board and starter solenoid or MFD wireConnect one of the test leads to the redpurple wire and the other lead to the yellowred
wireDepress start buttonThe reading should be .3 ohms or lessA high resistance or open reading indicates faulty switchRelease
start buttonAn open reading (OL) should be indicatedIf low resistance is measured, replace the switchco co co Engine Stop
Switch Testing 123Set multitester to ohms (Q) positionUnplug stop switch connector (blackyellow and black wires)Connect one
of the test leads to the blackyellow pin and the other lead to the black pinPush kill button or disconnect tether cordThe
reading should be .3 ohms or lessConnect tether cord and release buttonAn open reading should be indicatedIf not, replace