1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 308Get this manual

1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 308

ELECTRICAL Starter Motor Brush Replacement 1Remove terminal nut with lock washer, flat washer, large phenolic washer, small
should indicate .3 ohms or less Measure resistance between commutator and armature shaftReading should be infinite (OL)Inspect
surface of commutator wear or discolorationReplace if excessively worn or damaged 3Place armature in growlerWith growler
on, position hacksaw blade lengthwise, 18" (.3 cm) above armature coil laminatesRotate armature 360If the hacksaw blade is
drawn toward the armature on any point, the armature is faulty and must be replaced4Inspect permanent magnets in starter
housingMake sure they are not cracked or separated from housingIII ::::I I: III ;;0 111 III Use care when handling starter