1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 331Get this manual

1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 331

ELECTRICAL Ignition Timing Adjustment Dynamic Ignition Timing, Cont12Point timing light at inspection holeBe sure to view
Static Timing Light tool (PN 2871745) can used to check ignition timing on Polaris engines equipped with hall effect sensorsBe
sure to set the timing to the "Static Timing Reference Location" shown in Static Timing Table when using the Static Timing
Light1Make sure there is good 9v battery in the tool2Open electrical box, disconnect brown stator lead and connect it to
brown lead of tester3Disconnect black stator lead and connect it to black lead of tester4Connect white wire to Red (Magneto
cylinder-#1) stator wireNOTE: The white wire on the tool is the sensor wire and must be connected to the Mag cylinder Hall-Effect
sensor wireRedMag (#1) cylinder5Remove spark plugs and install dial indicator (with extension) in the Magneto (1) cylinderFind
Top Dead Center (TDC)6Rotate crankshaft counterclockwise (as viewed from front) until light comes onContinue rotating in