2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 103Get this manual

2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 103

http:ReadManm FUEL SYSTEMCARBURETION Mixture Screw SettingsKeihin Idle Speed On Genesis FFI"" models, the EMM is programmed
in altitude and temperatureThe base settings should not be changedIf large adjustments are necessary for proper mixture,
the carburetors, fuel system, and engine should be inspected to find the cause of rich or lean condition(See Lean Condition
Troubleshooting in Maintenance section If the carburetor has been tampered with or disassembled before exact base settings
were recorded, use the following procedure to adjust each screwNote:The base settings are for elevations between sea level
and 3000 ft(900 meters)12Remove limiter cap(s)Turn mixture screw in until lightly seated, then turn screw out the specified
number of turns (see specifications in beginning of this chapter)Reinstall limiter cap(s) with tab positioned mid-way between
the stops to allow slight adjustment in each directionTest the craft under actual operating conditions to verify proper mixture4