2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 183Get this manual

2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 183

http:ReadManm FINAL DRIVEJET PUMPBILGE SYSTEM Pump Assembly Pump Assembly NOTE: To ease installation, wrap bearings in wax
to center spacer and press remaining bearing into opposite end of housingRemove stub shaftApply marine grease to seal lips
and also between the two sealsInstall two new oil seals as shown with both springs and lips up and visible (toward impeller)Press
seals to bottom of chamfer on seal bore (about 18".32 cm beyond end of bore) NOTE: Check pump alignment before installing
stub shaft and impellerSee page 5.23-5.26Grease and install two new O-rings on stub shaftAlign bearing spacer carefully and