2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 189Get this manual

2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 189

http:ReadManm FINAL DRIVEJET PUMPBILGE SYSTEM Pump Drive Shaft Alignment The drive shaft must be properly aligned to prevent
cord lock plate from engine stop switchRemove battery negative cableRemove driveshaftpump assembly(See pump removal this
section)Remove bearing housing from through-hull fittingRemove tail coneRemove impeller and stub shaft from pump housingInspect
bearings for wear or damage and replace if necessarySee Pump DisassemblyInspection this sectionAssemble pump without stub
shaft, impeller, or tail coneInstall stator housing to pump housinglighten mounting bolts to 18 ftIbs(24.8 Nm) Install alignment
tool into pump bearing housing with the smaller diameter coupler end facing toward engineSlide coupler end of alignment tool
into drive couplerWatercraft EnginePump Alignment Tool PN 2871343 the tool will slide freely into the engine coupler 10If
engine and pump are properly aligned, 11If mis-alignment is evident, determine the probable cause of misalignment from the