2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 220Get this manual

2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 220

http:ReadManm HULUDECK, STEERING AND CONTROLS SMC Repair SMC Hull Repair The hull on some models is constructed of sheet
use power sanding equipment on the repair area or bond strength may be affectedHand sand only NOTE: For bonding use 3M #08101
structural adhesive or equivalentExample shown is through hull fitting installationBasic preparation procedure is the same
for repairing damaged hulldeck components1Remove all original adhesive and sand the area to be repaired with 80 grit paperPower
sanding is not recommendedbond strength may be adversely affectedUse acetone or lacquer thinner to clean and prime the area
around the repairMix parts and of the structural adhesive, apply to the fitting and hull, and immediately press the parts
into place holding pressure for at least two minutes until the adhesive begins to set upHandling strength should be achieved