2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 254Get this manual

2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 254

http:ReadManm ELECTRICAL Trigger Coil Testing2000 Virage TX SLX Pro 1200 Genesis Trigger Coil (Hall Effect Sensor) Testing
should indicate an open circuit (00) until the magnet in the magnet holder passes by the sensorAt this pOint the reading
should switch to low resistance (under 25 ohms)It should go back to infinite as flywheel rotation continuesRepeat the test
for the other trigger coilsOhmmeter To Green, Red, or Blue wire NOTE: Actual resistance readings may vary with different
metersA specific resistance reading is not criticalThe reading must, however, switch sharply from high to low resistance,
and then back again as the flywheel is rotated Alternate Method Of Testing Hall Effect Sensors Static liming Ught tool (PN
2871745) can used to test Hall Effect sensorsSimply connect the white test wire to the Red (Mag), Blue (Cen), or Green (PTa)
wire from the statorIf the sensor is functioning properly, the light will turn on and off as indicated in Static Timing Procedure