2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 291Get this manual

2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 291

http:ReadManm FFI1M FUEL INJECTION Action StepsFuel System Step 5: Voltage Supply TestsBattery must be of adequate capacity,
20 voltsCheck WhiteRed wire and groundEngine runningmore than 24 volts and steady at idleMore than 40 volts and steady above
3500 RPMResults: As specifiedcheck supply voltage at injectorGo to Step DAny less than specifiedtest charging system1M EMM
Service Power Con- ECheck injector supply voltage at the leads of each injector connector using PDS(injector) jumper tool
PN 2872623Voltage can also be monitored using FFI 1M Diagnostic SoftwareResults: Same results in Stepall OKNo voltage on
somecheck voltage at the blue (29), purple (19), and green (9) injector wires of the EMM pin outOKrepair wire or replace
engine wiring harnessInspect connector at injection and wire harnessNo voltage on all Check voltage at pin connector and
7No voltage on and 7, check Ohm test on stator windingsIf OK, replace the EMM Conclusion The fuel system should now operate