2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 292Get this manual

2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 292

http:ReadManm FFI TM FUEL INJECTION Action StepsIgnition System ACTION STEPSIGNITION SYSTEM Step 1: Visually inspect all
TestsThe battery must be fully charged, with all connections clean and tightAVerify tether cord is connected to stop switch
NOTE: Perform the following tests while problem is occurringBVerify fused B+(battery positive) is present at RedPurple wire,
terminals and of the PCM (see Chapter 9, page 27)Check should show either 9.5 or more volts while cranking, or 12 or more
volts while running OKgo to Step CLow voltage while cranking: -Verify battery capacity, condition, and connectionsTest voltage
drop across battery cables and starter solenoid-Test current draw of starter motorSee Engine Section CVerify output voltage
to EMM at stator connectorsCheck for both of the following at 12 pin connec tor across any yellow wires Tether cord connected
to stop switchengine not runningCrankingapproximately 20 volts Results: As specifiedVerify continuity of wires between stator
and EMMIf OKreplace EMMVoltage can also be monitored using FFI TM Diagnostic Software Step 6: Running TestMonitor voltages