2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 297Get this manual

2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 297

http:ReadManm DIAGNOSTIC SOFTWARE Setting Up The EMM 1Locate the diagnostic port on the engine wiring harnessIt is positioned
Overview The FFI1M Diagnostic software program can either be run from your computer's "A" drive, or "C" driveInstalling the
software on your computer's "C" drive will allow the program to run much faster, as well as retain previous consumer FFI1M
information on your hard driveFor 2000, the FFI diagnostic software disk has been upgraded with special boot programThis
program was developed to overcome problems with the software not communicating with the EMMWhen used, your computer will
immediately boot, load, and run the FFI diagnostic software without any input from the user1M 1M Starting the Diagnostic
Session with the Boot Program NOTE: The following procedure should only be performed if you have previously installed the
FFI tic software on your computer, but the software is unable to communicate with he EMM1If already on, turn your computer