2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 301Get this manual

2000 Polaris Virage TX, SLX, Pro 1200, Genesis, Genesis FFI Personal Watercraft Service Manual, Page 301

http:ReadManm DIAGNOSTIC SOFTWARE Error Messages If the program doesn't start, an error message will appear explaining the
cable intoMake sure the diagnostic program is set up to use the same portSee the section titled Changing Com Port in this
bookletSome computers have the ability to enable and disable the com portsConsult the documentation that came with your computerMake
sure the com port is enabled Something is already using the com portThis is usually caused by mouse driver that is loaded
in the Config.sys file or Autoexec.bat fileIf you are using DOS or newer, you can bypass the Config.sys and Autoexec.bat
files by restarting your computer and pressing the "FS" key when you see the "Starting MSDOS" messageIf you are using an
older version of DOS, you will have to remove the command that loads the mouse driver by editing the Config.sys or Autoexec.bat