2001 Polaris SLH, Virage PWC Factory Service Manual, Page 57Get this manual

2001 Polaris SLH, Virage PWC Factory Service Manual, Page 57

Maintenance HullControl SystemsContinued Adjustment ProcedureContinued 5Use main cable adjuster nuts to make major adjustments
procedures Use main cable nuts for major adjustmentsTighten securely Torque to 22 ft .lbs(30Nm) Reverse Cable Adjustment
The reverse cable does not require periodic adjustmentIf the reverse linkage does not function properly, inspect the cable
for damageInspect all linkagefastenersbracketsand pivots for wear or damageWhen new cable is installed the cable must be
adjusted1N Place reverse shift lever in reverse position Loosen cable adjuster nuts Adjust cable until reverse gate is above
the water stream in its up position Check gate locking by pulling up on gate when in down position Move shift lever to forward
positionReverse gate must be above water stream 6Tighten adjuster nuts securely7Seal the cable threads and adjuster nuts