2001 Polaris SLH, Virage PWC Factory Service Manual, Page 109Get this manual

2001 Polaris SLH, Virage PWC Factory Service Manual, Page 109

EngineCooling Engine Installation 700cc Engine Engine installation is done in reverse order of the removal instructions few
freely and return completely when released Verify proper operation of engine stop switchAfter engine installationpump alignment
must be inspectedRefer to the Final Drive section for inspection and alignment proceduresSynchronize carburetors and be sure
they are clean Adjust oil pump cable and bleed pumpThe first tank of fuel should be pre-mixed with Polaris Premium cycle
or Premium Synthetic cycle oil or Nature Oil at 40:1 ratio CAUTION: I Shims used for engine and driveshaft alignment must
be reinstalled in their original locations Do not allow them to be mixed upAlways verify proper engine to pump alignment
after engine installation as outlined in the Jet Pump, Final DriveBilge sectionIn most cases, the number of shims used in
production is marked in permanent marker next to each engine mountThe same number must be installed as starting point, and
in most cases adjustment will not be necessaryAlways verify proper engine alignment before installing pump46Install the engine