2001 Polaris SLH, Virage PWC Factory Service Manual, Page 178Get this manual

2001 Polaris SLH, Virage PWC Factory Service Manual, Page 178

Final DrivePropulsion Pump Alignment- SLHVirage NOTE: Checking the pump alignment is not required if the alignment is not
section Apply Marine Grade Silicone Sealant PN 8560054 4Assemble pump without stub shaft, impeller, or tail coneInstall stator
housing to pump housingmounting bolts to 18 ftIbs(24.8 Nm) Tighten Alignment Tool PN 2871343 Stator Housing Mounting Bolt
Torque18 ftIbs(24.8 Nm) Install alignment tool into pump bearing housing with the smaller diameter coupler end facing toward
engineSlide coupler end of alignment tool into drive couplerIf engine and pump are properly alignedthe tool will slide freely
into the engine couplerIf mis-alignment is evident, determine the probable cause of misalignment from the following chart