2001 Polaris SLH, Virage PWC Factory Service Manual, Page 207Get this manual

2001 Polaris SLH, Virage PWC Factory Service Manual, Page 207

HullControl Systems SMC Hull Repair The hull and top deck on some models are constructed of sheet molded compound (SMC) which
in General Information section for paint colorsCAUTION: Do not use power sanding equipment on the repair area or bond strength
may be affected Hand sand onlyNOTE: For bonding use 3M #08101 structural adhesive or equivalentBasic preparation procedure
is the same for repairing damaged hulldeck components1Remove all original adhesive and sand the area to be repaired with
80 grit paperPower sanding is not recommendedbond strength may be adversely affectedUse acetone or lacquer thinner to clean
and prime the area around the repair Mix parts and ofthe structural adhesive, apply to the fitting and hulland immediately