2001 Polaris SLH, Virage PWC Factory Service Manual, Page 247Get this manual

2001 Polaris SLH, Virage PWC Factory Service Manual, Page 247

Electrical Systems Starter MotorTroubleshooting Condition: Starter fails to turn motor or motor turns slowlyDynamic testing
cablePush the start button The reading must be less than .1 DCIs it? No- Vest With the black tester lead on ground, check
for voltage at the large relay in terminal, the circuit breaker in and out terminalsand across both sides of the start switch
with the switch on startRepair or replace any defective part(s) Clean the battery to solenoid cable ends or replace the cable
Connect the black tester lead to the solenoid end of the battery-to-solenoid cable and the red tester lead to the solenoid
end of the solenoid-to-starter cable Push the start buttonThe reading must be less than .1v DCIs it? No- Ves Connect the
black tester lead to the solenoid end of the solenoid-to-starter cable and the red tester lead to the starter end of the
same cablePush the start buttonThe reading must be less than .1v DC Is it? No- Vest Connect the black tester lead to the
starter frame Connect the red tester lead to the battery negative terminalPush the start buttonReading should be less than