2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 71Get this manual

2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 71

Maintenance General Troubleshooting For OFI1M troubleshooting, see Chapter 8, FFI1M Fuel InjectionThe following information
or lines Water present in fuel system Water in carb fuel chambers between diaphragm, jet block and jets Kinked or restricted
fuel tank vent or fuel lines Fuel tank inlet check valve damaged, faulty, or improperly installed Vent lines kinked Air leaks
at fuel pickup connections or lines between pump and tank Fuel pickup tube disconnected or loose in tank Fuel pump impulse
line pinched, kinked, restricted with oil or water, or leaking Carburetors dirty; main pilot or bypass orifices restricted;
fuel inlet screen plugged Carburetor synchronization incorrect Water separator full or restricted Water in fuel tank High
or low speed screws adjusted incorrectly; jets too small or restricted Fuel pump diaphragm or check valve damaged Fuel filter
restricted Carburetor jetting incorrect Fuel tank pickup screen plugged Air leaks in engine intake tract (carburetor base
gaskets, reed gaskets, synchronizing plugs, etc Carburetor inlet needle or control lever arm stuck or adjusted incorrectly