2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 94Get this manual

2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 94

EngineCooling Engine RemovalAll 1200 ModelsContinued 9Locate the stator wiring harnessDetach the harness from either the
standard screwdriver into the Shrader valvePoint valve into suitable containerPress screwdriver into nozzle gently to let
fuel out16On DFI1M models, loosen and remove the six (6) fuel injector hold-down boltsThe fuel injectors can be removed as
an assemblyWrap injectors in plastic bagLay injectors in footwell on towel17Disconnect the oil inlet hose from the oil pumpUse
bolt and clamp to cap-off the oil line18Loosen and remove the four(4} engine mount nuts NOTE: Engine-to-pump alignment is
controlled by shims inserted between the engine mount and mount plateBefore removing any shims, note their location and number
used19Prior to removing DFI 1M engine, detach the following sensors from their wiring harnesses: Coolant Temperature Sensor