2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 109Get this manual

2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 109

EngineCooling Engine InspectionAll 1200 ModelsContinued Honing Procedure, Cont2Place hone in cylinder and tighten stone adjusting
with 12"1" (12-25mm) diameter cylindrical grinding stone or sanding roll, half round file, or sided de-burring knifeHold
the cylinder securely by installing bolts in the exhaust mounting holes and clamping in soft jaw viseThe corners, top and
bottom edges of ports should receive standard chamfer (.3 -.6mm) with the widest portion at the center of the port windowThe
sides of the ports require only de-burring (.05.3mm)Refer to illustration below Cylinder IMPORTANT: Cleaning the Cylinder
After Honing Scrub the cylinders thoroughly in hot, soapy waterPay close attention to the area where the cylinder sleeve
meets the aluminum casting and use electrical contact cleaner if necessary to remove all traces of debrisRinse the cylinders
in clear water and dry thoroughly with compressed airImmediately apply Polaris Premium Cycle Lubricant or 2-stroke engine