2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 163Get this manual

2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 163

CarburetionExhaust Carburetor DisassemblyInspectionContinued 3Inspect passage sealing a-ring and replace if worn or damagedThe
for signs of hardening, stretched or weak areas, holes, or tears 7Measure control arm height from machined surface to top
of plastic button on control armRemove screw and remove control arm and inlet needle .060" 1.5 mm NOTE: Top of plastic button
#2 should be .060 "(1.5 mm) below casting surface #1 as per illustration at rightVariances in control arm positioning will
result in incorrect fuel supplyIf the control arm is too close to the diaphragm, fuel levels will increase, resulting in