2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 173Get this manual

2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 173

CarburetionExhaust Idle Speed Adjustment On OFI models, the EMM is programmed to idle at 1100 RPM50The idle speed cannot
allow only slight adjustment of the screws in each direction to compensate for changes in altitude and temperatureThe base
settings should not be changedIf large adjustments are necessary for proper mixture, the carburetors, fuel system, and engine
should be inspected to find the cause of rich or lean condition(See Lean Condition Troubleshooting in Maintenance section
If the carburetor has been tampered with ordisassembled before exact base settings were recorded, use the following procedure
to adjust each screwNote:The base settings are for elevations between sea level and 3000 ft(900 meters)1Remove limiter cap(s}2Turn
mixture screw in until lightly seated, then turn screw out the specified number of turns (see specifications in beginning