2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 215Get this manual

2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 215

Final DrivePropulsion Stator Assembly NOTE: Seals, bearings, and a-rings should be replaced if removedHeat the impeller housing
marine grease to seal lips and also between the two sealsInstall two new oil seals over impeller spacer with lips up and
visible (toward impeller)Press seals to bottom of chamfer on seal bore (about 18"1.32 cm beyond end of bore) WARNING: Never
allow the impeller spacer to push up through the two seals when inserting the stub shaftIf spacer pushes though seals, the
seal lips will be compromised and allow water into bearing housingGrease and install two new a-rings on stub shaftMount stub
shaft flats in viseGrasp stator assembly with thumbs over impeller spacerCarefully lower assembly over stub shaftVerify that
stub shaft has not pushed impeller spacer up through seals NOTE: If impeller spacer has pushed up through seals, push into