2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 217Get this manual

2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 217

Final DrivePropulsion Pump AlignmentContinued Troubleshooting Symptoms Probable Cause Repair Required Shim engine mounts
pump housing as shown on Page Excessive drive line vibration Drive shaft runout excessive Loose or broken engine mounts Engine
loose on mount plate Pump-to-hull or engine-to-pump alignment incorrect Engine Alignment Inspection (Vertical) 1If vertical
mis-alignment is evident, loosen engine mount nuts and add or remove shims between mount plate and rubber engine mounts (equally
on both sides) to raise or lower the couplerNOTE: Before shimming engine, be sure misalignment Front of Watercraft Front
of Watercraft is not caused by problem in the pump mounting area, such as loose mounting fasteners; improperly installed
pump mounting studs; hull damage, etcAlignment Tool Too High (See NOTE:) 2To raise coupler: Add shim(s) to the rear mounts
or remove shim(s) 'from frontTo lower coupler: Remove shim(s) from rear mounts or add shim(s) to frontThe number of shims
installed in production is written next to each mount in permanent marker on late models Bearing Carrier Drive Coupler "