2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 219Get this manual

2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 219

Final DrivePropulsion Driveshaft Lubrication Grease the drive shaft coupler, and bearing carrier any time water in the watercraft
the instructions below in order to avoid personal injury Driveshaft CouplerBearing Housing Lubrication 1234Remove lanyard
cord and lock plate from the engine stop switchRemove seatRemove battery ground (-) cableLoosen clamp holding plastic driveshaft
shroud in place and rotate it 180: Bonded rubber couplers: drive shaft must be removed to grease splinesSee maintenance guidelines
in Maintenance Section, and refer to drive shaft removal in this sectionlocated on coupler itself 5Solid Coupler: Lubricate
coupler via grease fitting 6Lubricate bearing housing at grease fitting until grease purges past the sealsUse only Polaris