2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 300Get this manual

2001 Polaris SLX, PRO 1200, Virage TX, Genesis, Virage TXi, Genesis i Personal Watercraft Service Manual, Page 300

Electrical Systems Warning Systems Coolant Temperature Warning Circuit Operation The MFD light is controlled by temperaturewarning
and with the wires disconnected, contact one test probe to the switch terminal and the other test probe to engine groundThe
meter should show an open circuitHeat the switch in water bath to the "on" temperature listed on page 7.3Measure resistance
of the switchReading should be less than .4 ohms When testing the switch, heat only in water bathNever subject the sensor
to an open flame or sensor damage will resultDo not immerse the wires in the water bath Fuel Sender Operation and Sender
Testing The fuel gauge is operated through voltage signal at the fuel tank sending unitThe sending unit resistance changes
with the height of the float in the senderTo check for proper sending unit operation connect an ohmmeter to the wires as
shown Sending unit Check all wiring connections and refer to the wiring diagram at the end of this section for correct connections